Error installing ATG drives

Question

Hello,  
I'm trying to run Using-PCIM-Port example from https://github.com/awslabs/aws-fpga-app-notes/tree/master/Using-PCIM-Port  
  
Following the read me, I was able to Load AFI, (agfi-0d132ece5c8010bf7) build ATG drivers and by the time I install I hit on a Error   
  
sudo insmod atg_driver.ko slot=0x0f  
insmod: ERROR: could not insert module atg_driver.ko: Device or resource busy.   
  
dmesg logs:  
\[  181.293259] IPv6: ADDRCONF(NETDEV_UP): ens3: link is not ready  
\[  181.388658] IPv6: ADDRCONF(NETDEV_UP): ens3: link is not ready  
\[  181.749638] IPv6: ADDRCONF(NETDEV_CHANGE): ens3: link becomes ready  
\[  182.766973] tun: Universal TUN/TAP device driver, 1.6  
\[  182.771777] tun: (C) 1999-2004 Max Krasnyansky   
\[  182.778610] virbr0: port 1(virbr0-nic) entered blocking state  
\[  182.783989] virbr0: port 1(virbr0-nic) entered disabled state  
\[  182.789778] device virbr0-nic entered promiscuous mode  
\[  182.955985] virbr0: port 1(virbr0-nic) entered blocking state  
\[  182.961290] virbr0: port 1(virbr0-nic) entered listening state  
\[  182.966475] IPv6: ADDRCONF(NETDEV_UP): virbr0: link is not ready  
\[  183.013277] virbr0: port 1(virbr0-nic) entered disabled state  
\[  838.922911] Installing atg module  
\[  838.926951] vendor: 1d0f, device: f001  
\[  838.931777] Enable result: 0  
\[  838.935241] xdma 0000:00:0f.0: BAR 0: can't reserve \[mem 0xc4000000-0xc5ffffff]  
\[  838.943842] atg_driver: cannot obtain the OCL region  
  
How can I fix this ?  
I'm using a x16 card on centos.  
  
Edited by: TJ25 on Mar 30, 2020 9:02 AM

Answer

Hi TJ25,  
  
Could you check if xdma is inserted at this point?

```
lsmod | grep xdma
```

If it is, try removing it and you should be able to insert the atg driver.

```
sudo rmmod xdma;
sudo insmod atg_driver.ko slot=0x0f;
```

-Deep

Error installing ATG drives

Relevanter Inhalt