Connect Contact Flow playing a DTMF tone

Question

I have a use case where an end to a Contact Flow needs to play a DTMF tone. I have this setup by the Contact Flow playing a .wav file in a prompt.  
    
I have confirmed the .wav file plays, as I have added an audio clip to the beginning of the file preceding the DTMF tone and this preceding audio can be heard, but still not the DTMF tone.   
    
Is there a way to have a DTMF tone originate from Connect and send outbound?  If this is not possible through Connect alone, would it be possible by integrating a Lambda function to play the file from S3? I was going to build this, but it seems more likely the issue is with DMTF going outbound from Connect in general.  
  
Thank you for your input.  
  
Edited by: JDIO on Feb 16, 2019 11:22 PM

Answer

I experience similar issue with 2 way hands free devices which rely on dtmf tones to switch between talk and listen modes. Were you able to find a solution to your issue?   
  
P.

Answer

Updating for anyone else with future need:    
    
The DTMF tone does flow through, it was/is simply not audible through my test receiver. I am unsure if this is unique to my setup or will be experienced across all use cases, however the functionality is still there.

Connect Contact Flow playing a DTMF tone

Relevanter Inhalt