- Neueste
- Die meisten Stimmen
- Die meisten Kommentare
Check if you have configured Bidirectional Forwarding Detection (BFD). BFD is a simple hello mechanism that detects failures in a network.
BFD is not configured between the peers and I am not sure its even supported on the AWS side while configuring over IPSEC.
Regardless we don't seem to converge within 10seconds so i doubt BFD configuration if possible would make any difference.
BFD needs to configure on Direct connect. you need to check with your vendor.
check below link for example.
https://aws.amazon.com/premiumsupport/knowledge-center/enable-bfd-direct-connect/
As I have mentioned in my question, we are using the IPSEC tunnels and not direct connect so not sure how I can use BFD in my scenario. I know BFD is supported on direct connect but the problem is related to IPSEC tunnel convergence.
Relevanter Inhalt
- AWS OFFICIALAktualisiert vor 9 Monaten
- Wie verbinde ich verschiedene Zweigstellen mithilfe von AWS Site-to-Site VPN und AWS Direct Connect?AWS OFFICIALAktualisiert vor einem Jahr
- AWS OFFICIALAktualisiert vor 10 Monaten
- AWS OFFICIALAktualisiert vor 2 Jahren