Hello,

The power LED (yellow light) usually continues to flash if the deeplens device is in factory reset mode where the deeplens firmware is about to be re-flashed into the device. In your case, this can be due to the device being in an inconsistent state during the factory reset process. To address this behavior, kindly attempt restoring the device to factory settings [1]. You will need to download the respective firmware based on whether you are using deeplens V1 or V1.1, and proceed with the flashing process as detailed in the guide. You will also see a terminal flash on the screen, however no user input is required on the terminal.

Once the factory reset is complete, the LED will stop flashing and you will be able to use the device. Hope I answered the question properly, if not please reach out to AWS Support[2] (Deeplens), along with your issue/use case in detail and share relevant AWS resource names.

References

[1] Restoring your AWS DeepLens device to Factory Settings https://docs.aws.amazon.com/deeplens/latest/dg/deeplens-troubleshooting-factory-reset.html [2] Creating a Support case https://docs.aws.amazon.com/awssupport/latest/user/case-management.html#creating-a-support-casehttps://docs.aws.amazon.com/awssupport/latest/user/case-management.html#creating-a-support-case