1 Resposta
- Mais recentes
- Mais votos
- Mais comentários
2
You are only seeing the information for DX-1 because you are only specifying that neighbor in your show command. If you want to see all BGP routes to the remote site, use the command: show ip bgp
This will list all BGP peers and routes, and also show and values for weight, local pref and the AS Path. There should be a > symbol that shows the preferred path, but as long as the number of hops (AS Path) is equal along with the other values mentioned, both circuits will be leveraged. Take a look at this cisco article: https://www.cisco.com/c/en/us/support/docs/ip/border-gateway-protocol-bgp/13762-40.html#toc-hId--255936387
Conteúdo relevante
- AWS OFICIALAtualizada há 9 meses
- AWS OFICIALAtualizada há 2 anos
- AWS OFICIALAtualizada há um ano
This is my show ip bgp
10.20.0.0/16 is towards region-A and 10.21.0.0/16 towards region-B but still outbound from CISCO router takes only 169.254.96.20 neighbor....
i think you nailed it...i was missing maximum-paths command. Now i see below entry..m multipath..thanks a lot for quick solution and ref doc
*m 10.20.0.0/16 169.254.96.10 150 0 65005 i *> 169.254.96.20 150 0 65005 i *m 10.21.0.0/16 169.254.96.10 150 0 65005 i *> 169.254.96.20 150 0 65005 i