I could use some guidance on improving data transfer speeds while using Robocopy to copy data into an FSx filesystem. Some details
Data source is outside AWS cloud (However, transfer tests from an EC2 instance in same subnet was below par)
No Direct Connect but provisioned network throughput into AWS is not a bottleneck (confirmed with Diskspd)
FSx Filesystem uses SSD drives (yeah I tried HDD but SSD is not pulling its weight either.)
Robocopy parameters: disabled ACLs capture to rule out permissions errors; tried thread counts of 50 through 128; output redirected to log file; no restartable mode
Data throughput looks promising at the start but tails off after about an hour.
FS filesystem dashboard occasional generates a warning about Disk IOPS utilization (SSD); recommends I increase storage capacity even though there is plenty of free space after transfer is complete!
I tried DataSync. Performance was poor (I really did not expect much from an appliance acting as a data relay.)
Can anyone vouch for Robocopy as a tool for bulk data migrations into FSx from outside the AWS cloud?
AWS 官方已更新 1 年前
I tried your suggestion but observed no improvement. After consulting with AWS support, apparently oversubscribing storage capacity is the "solution". Not cost-effective but then again the bulk transfers (with the need for speed) are temporary.