2 Respostas
- Mais recentes
- Mais votos
- Mais comentários
0
Hi,
I'd would suggest you to watch this video https://www.youtube.com/watch?v=NJaHPWX-4C4
Its first 3 mins are a fully detailled installation guidance.
In particular, around 2min30s, it explains how to connect JupyterLab's CodeWhisperer extension to AWS cloud in order to the reach the AI engine. Did you exactly do what is shown in your own install?
Best,
Didier
0
update: installed nodejs and got it to work.
but,
is acting very moody, needs 4-5 manual invokes to give a suggestion
and the suggestions are very bad,
will keep trying.
respondido há 4 meses
Conteúdo relevante
- AWS OFICIALAtualizada há 4 meses
- AWS OFICIALAtualizada há 2 meses
- AWS OFICIALAtualizada há 2 anos
Yes Didier, that video was my starting point, I have sussecfully gone through all the steps. Completed the Builder ID process successfully and even got the check mark next to the code whisperer on the JupyterLab interface (bottom footer). Even in the installed extensions, it shows up all enabled. All good.
But when I open a notebook and start working.... nothing. no suggestions. even on invoking it manually.